Raise requisitions for necessary spares immediately and update the work done and running hours in the planned maintenance system. Keep a detailed record of all clearances, spare parts consumed, and other maintenance work performed. Once you’re satisfied, test run the compressor and measure the time it takes to fill the air receiver from empty to full. Prime the lube oil pump and conduct an initial running of the compressor in anĬheck the motor amperage, noise levels, and other factors before loading the compressor. Renew the lube oil filters and airįilter, and open the cooling water valves to check for any leaks. If you are not sure how to measure bumping clearance in air compressor contact Turbo Airtech.īefore you start the compressor, make sure to clean or renew the oil suction filter and refill with new oil. Use a squeezable plastic or lead wire ball to measure the bumping clearance. Finally, suction and discharge valves must be either renewed or overhauled for best results.Īfter a major overhaul, be sure to check the clearance between the compressor and the housing & between the housing and gears to ensure it is still within specifications. Gaskets and rubber seals should be replaced with new parts to prevent leakage, and control valves should be stroke tested to ensure they areĪll nuts should be torque tightened to the correct settings, and new locking devices such as split pins should be used to keep them in place. To ensure optimal performance, it is important to inspect and renew major parts such as seals, valves, bearings, and more on a regular basis.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |